Finish Installation; Install The Cover - Chamberlain LiftMaster CSL24V Installation Manual

FINISH INSTALLATION

INSTALL THE COVER

The operator cover consists of two pieces: a rear cover and a front cover. The front cover can easily be removed to access the electrical box. To access the reset switch slide the
access door up. The front cover and access door can be locked with the key.
TO INSTALL THE COVER
1
Align the tabs on the rear cover with the slots on the chassis and place the cover
over the operator.
2
Secure both sides of the rear cover to the chassis with two 5/16-18 hex bolts
and washers.
3
Align the front cover with the back cover, making sure the grooves line up.
4
Secure the front cover to the chassis with two 5/16-18 hex bolts and washers.
5
Secure the front cover to the rear cover using the 5/16-18 screw.
TO LOCK THE ACCESS DOOR
From the factory the access door for the reset switch will not be locked. To lock the
access door follow the steps below:
1
Locate the lock tab on the back of the front cover and remove the screw
securing the tab to the cover.
2
Turn the tab 180 degrees, then secure with the screw. The access door can now
be locked.
The basic installation is complete.
Tabs on Rear Cover
Factory Default position
24
INSTALL THE COVER
5/16-18
Hex Bolts
and Washers
Slots on Chassis
Groove on Front Cover
Access Door
Lock Tab
Access Door
(back of front cover)
5/16-18
Screw