Teaching-In - HomeMatic HM-CC-RT-DN Installation And Operating Manual

ceed as follows:
• Press the Boost button ( ) when „InS" is displayed.
Now the actuator performs an adapter run. „AdA" and
the activity symbol (
operation is not possible. Afterwards, the display will
change to normal.
If the adapter run has been initiated prior to
mounting or if an error message (F1, F2, F3) is
displayed, press the Boost button; the motor re-
verses to the „InS" position.
Teach-in mode can be activated even whilst
„InS" is still displayed. Therefore, please pro-
ceed as explained in sec. „8 Teaching-in".
8

Teaching-in

Please read this entire section before
starting the teach-in procedure.
72
) are displayed; during this time,
Before being able to use your device with
QIVICON, it has to be taught-in to your
QIVICON Home Base.
Therefore, please log-in to „My QIVICON" at
www.qivicon.com/login. There, please select
„Add device" and follow the instructions.
To integrate the radiator thermostat into your Home-
Matic system and enable it to communicate with
other HomeMatic devices (e.g. HomeMatic Window
Contact), you must teach it in first. You can teach-in
the radiator thermostat directly to other HomeMatic de-
vices or to the HomeMatic Central Control Unit:
8.1 Teaching-in to HomeMatic devices
If you would like to teach-in the radiator thermostat
to one or more HomeMatic devices, you must put the
devices to be taught-in into teach-in mode and select
the required teach-in channel. To do this, proceed as
follows:
During teach-in, please make sure you maintain a
distance of at least 50 cm between the devices.
• Activate the teach-in mode of you radiator thermo-
stat. Therefore, press and hold the Boost button ( )
for at least 3 seconds.
73