Teaching And Unteaching Of Devices "Kon - HomeMatic HM-CC-TC Installation And Operating Manual

Radio-controlled

Hide thumbs Also See for HM-CC-TC:

Table of Contents

Available languages

Press the "OK" button to call up the information on the sensors.

The window symbol and the window position ("OPE" or "CLO")

are shown on the display. If the battery is low, the battery symbol

will also be shown. If the radio connection between the sensor

and the controller is interrupted, the antenna symbols will also

ﬂash. Use the setting dial to switch between the taught sensors.

8.5

Teaching and unteaching of devices "KON"

After selecting this menu point, the new device can be taught to

the heating controller or devices that have already been taught

can be untaught.

Call up special function "KON".

Press the "OK" button.

Now, choose whether you want to teach or unteach with the

setting dial:

Teach ("ADD")

The device is now in teach mode for approx. 20 seconds. If a

component has been taught successfully during this time, "OK"

appears on the display.

Unteaching ("DEL")

Unteaching is only possible if the room thermostat has not be

taught on a center station.

Use the setting dial to select the components that should be

untaught. Valve drives are only shown by their device number on

the display, shutter contacts or door window rotary handle sen-

Table of Contents

Do you have a question about the HM-CC-TC and is the answer not in the manual?