Installing The Memory Module - LanParty X48 User Manual

Installing the Memory Module

Note:
The system board used in the following illustrations may not
resemble the actual board. These illustrations are for reference
only.
1. Make sure the PC and all other peripheral devices connected to
it has been powered down.
2. Disconnect all power cords and cables.
3. Locate the DIMM socket on the system board.
4. Push the "ejector tabs" which are at the ends of the socket to
the side.
Ejector
tab
5. Note how the module is keyed to the socket.
Hardware Installation
DIMM sockets
Notch
Key
2
Ejector
tab
21