Installing The Memory Module - LanParty P45 T2RS User Manual

2
Hardware Installation

Installing the Memory Module

1. Make sure the PC and all other peripheral devices connected to
it has been powered down.
2. Disconnect all power cords and cables.
3. Locate the DIMM socket on the system board.
4. Push the "ejector tabs" which are at the ends of the socket to
the side.
Ejector
5. Note how the module is keyed to the socket.
20
Note:
The system board used in the following illustrations may not
resemble the actual board. These illustrations are for reference
only.
tab
DIMM sockets
Notch
Key
Ejector
tab