LanParty X48 User Manual page 38

2
Hardware Installation
Safe Boot
This jumper is used to safely reboot the system whenever the sys-
tem hangs and you are unable to restart the system.
1. Power-off the system then unplug the power cord.
2. Set pins 2 and 3 to On. Wait for a few seconds then set the
jumper back to its default setting, pins 1 and 2 On.
3. Plug the power cord then power-on the system. The system will
reboot normally without losing all data stored in the CMOS.
38
1 2 3 1
JP1
1-2 On: 2-3 On:
Default Safe boot
2 3