LanParty X48 User Manual page 75

Soft-Off by PWR-BTTN
This field allows you to select the method of powering off your
system.
Delay 4 Sec. Regardless of whether the Power Management func-
tion is enabled or disabled, if the power button is
pushed and released in less than 4 sec, the system
enters the Suspend mode. The purpose of this func-
tion is to prevent the system from powering off in
case you accidentally "hit" or pushed the power but-
ton. Push and release again in less than 4 sec to
restore. Pushing the power button for more than 4
seconds will power off the system.
Instant-Off Pressing and then releasing the power button at
once will immediately power off your system.
PCI Express PME
This field is used to configure the PCI Express PME.
Run VGABIOS if S3 Resume
When this field is set to Auto, the system will initialize the VGA BIOS
when it wakes up from the S3 state. This can be configured only if
the "ACPI Suspend Type" field is set to "S3(STR)". When this feature
is disabled, the system resume time is shortened but system will
need an AGP driver to initialize the VGA card. Therefore, if the AGP
driver of the card does not support the initialization feature, the
display may work abnormally or not function after resuming from S3.
Wake-Up by PCI Card
Enabled This field should be set to Enabled only if your PCI
card such as LAN card or modem card uses the
PCI PME (Power Management Event) signal to re-
motely wake up the system. Access to the LAN card
or PCI card will cause the system to wake up. Refer
to the card's documentation for more information.
Disabled The system will not wake up despite access to the
PCI card.
3
BIOS Setup
7 5