LanParty X48 User Manual page 71

IR Mode Select
This field is used to select the type of IrDA standard supported by
your IrDA device. For better transmission of data, your IrDA periph-
eral device must be within a 30
meter.
UR2 Duplex Mode
Half
Full
PWRON After PWR-Fail
Off
On
Former-Sts
CIR Port Address
This field is used to select an I/O address for the CIR device.
CIR Port IRQ
This field is used to select an IRQ for the CIR device.
o
angle and within a distance of 1
Data is completely transmitted before receiving
data.
Transmits and receives data simultaneously.
When power returns after an AC power failure,
the system's power is off. You must press the
Power button to power-on the system.
When power returns after an AC power failure,
the system will automatically power-on.
When power returns after an AC power failure,
the system will return to the state where you left
off before power failure occurs. If the system's
power is off when AC power failure occurs, it will
remain off when power returns. If the system's
power is on when AC power failure occurs, the
system will power-on when power returns.
3
BIOS Setup
7 1