LanParty X48 User Manual page 70

3
BIOS Setup
Power On By Button
To use the power button to power on the system, set this field to
Enabled.
KB Power On Password
Move the cursor to this field and press <Enter>. Enter your pass-
word. You can enter up to 5 characters. Type in exactly the same
password to confirm, then press <Enter>.
The power button will not function once a keyboard password has
been set in this field. You must type the correct password to power-
on the system. If you forgot the password, power-off the system and
remove the battery. Wait for a few seconds and install it back be-
fore powering-on the system.
Hot Key Power On
This field is used to select a function key that you would like to use
to power-on the system.
Onboard FDC Controller
Enabled
Disabled
Onboard Serial Port
Auto
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3
Disabled
Onboard IRDA Select
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3
Disabled
7 0
Enables the onboard floppy disk controller.
Disables the onboard floppy disk controller.
The system will automatically select an I/O ad-
dress for the onboard serial port.
manually select an I/O address for the onboard
serial port.
Disables the onboard serial port.
manually select an I/O address for the onboard
IrDA.
Disables the onboard IrDA.
Allows you to
Allows you to