Other Problems - Kodak DCS Pro 14n User Manual

Other Problems

Problem
Camera does not power on
Camera does not power on when
the power module is used
Camera does not recognize the
card in the camera
Shutter will not actuate.
Camera seems to be locked.
Cannot get out of custom settings
Camera seems to contain hidden
information. There is less space
on the card than there should be.
Four-way switch doesn't work
Card Busy LED and Card icon on
the Digital Status LCD are
blinking.
April 29, 2004
Cause
The power module may not be
fully inserted.
The card may be
malfunctioning.
The card may not work properly
with the camera.
There can be hidden recycle bin
folders on large cards if you
have deleted images from your
card using WINDOWS 2000.
Hidden recycle bin folders can
make your card seem smaller
than it should be.
Data is being written to the
memory card.
Remedy
Use a fully charged battery or the power
module.
Remove the memory card from the camera and
try to turn the camera on.
Be sure the cable is fully inserted into the power
module.
• You will feel and hear a soft "click" as the
cable is inserted properly in place.
• You may have to use a considerable amount
of push to "click" the cable in place.
Try a different card.
If you have access to the Image LCD menus,
reformat the card in the camera (see
page 4-14).
Try resetting defaults (see
Reformat the card in your camera if the space
on the card is smaller than it should be.
Be sure the Four-way switch lock is in the
unlock position.
Do not remove the card until the blinking stops.
Troubleshooting
page 5-12).
C-3