Black Box 12 VDC load User Manual page 16

GET[SET] TELNETTIMEOUT [N] (seconds)
GET[SET] TELNETPORT [N]
GET[SET] MONITORIP [X.X.X.X] (0.0.0.0 to disable)
GET[SET] MONITORMAC [X X X X X X] (X = HEX CHARS)
GET[SET] MONITORINTERVAL [N] (1/10 seconds, 0 to disable)
GET[SET] MONITORFAILCOUNT [N] (0 to disable)
GET[SET] MONITOROKCOUNT [N] (0 = no auto recover)
GET[SET] AUTHENTICATIONTRAP [ON/OFF]
GET[SET] ALERTTYPE [TRAP/SYSLOG]
GET[SET] ADMINIP N [X.X.X.X] (0.0.0.0 to disable an entry)
GET ADMINIP (display all administrator IP addresses)
GET[SET] MANAGER N [X.X.X.X] (0.0.0.0 to disable an entry)
GET MANAGER (display all SNMP managers)
PING X.X.X.X (ICMP ECHO to remote host)
SAVE save settings for next startup
RESET restart (use after SAVE)
SET DEFAULTS (restore default user settings, save required)
>
Notes:
Commands can be entered in upper or lower case.
•
All commands should be terminated with a carriage return (ASCII 13) or (hex 0x0D).
•
Set/get system commands can be abbreviated using just first letters, i.e. "g s" for "get system" or "s s a" for
•
"set system a".
8. Web Interface (
The network module installed in Ethernet remote control capable models of the A/B Switch also provides access to
console commands through a web browser interface. When enabled (see SET WEBENABLE command) entering
the A/B Switch's IP address (index.html) in your web browser's URL address line will present a log on page for the
A/B Switch similar to the following example. Note: If using a pop up blocker on your web browser, be sure to
allow pop ups from the IP address of the A/B Switch, otherwise you could experience trouble receiving a response
through the interface.
Web Interface Version 1.0
Copyright (c) 2008
All rights reserved.
Please logon:
Password:
Submit
A/B SWITCH WITH REMOTE INTERFACE
Ethernet remote control capable models
Figure 8.1 Logon Screen
)
Page 16 of 22