Black Box 12 VDC load User Manual page 14

SET AUTHENTICATIONTRAP ON[OFF]
GET AUTHENTICATIONTRAP
Set or display the current state of authentication error traps. Authentication traps will be generated when this
parameter is set to ON, and not when OFF. Note that this setting only affects the trap generation, and not how the
network module handles an authentication failure. An authentication failure generally means that an SNMP access
was attempted with an incorrect community name. Any change will not become permanent until a SAVE and
RESET operation sequence is performed.
SET ALERTTYPE [TRAP/SYSLOG]
GET ALERTTYPE
Set or display the type of alert messages sent by the A/B Switch when certain events such as a change in switch state
occur. The A/B Switch can be configured to issue either syslog messages, or SNMP traps. Note that at least one IP
address must be entered using the "SET MANAGER N X.X.X.X" command before either syslog messages or traps
will be issued. See section 9 for a list of the traps supported by the A/B Switch, and see section 10 for a list of the
supported syslog messages.
SET ADMINIP N X.X.X.X
Set administrator N (1-8) IP address. Up to 8 different administrator IP addresses can be entered. To remove an
entry from the list, set the IP address to 0.0.0.0. If all 8 ADMIN IP addresses are 0.0.0.0 (no ADMIN IP addresses
are configured) the A/B Switch will allow access via the Ethernet interface from any IP address, subject to the
existing password and enable flags for each interface. If one or more ADMIN IP addresses are non-zero, the A/B
Switch will only process messages received from the configured (non-zero) ADMIN IP addresses. All other
messages will be ignored. This ADMIN IP address filtering feature applies to the telnet, web browser and SNMP
Ethernet interfaces and to the PING reply functions. The ADMIN IP address filtering does not affect outgoing PING
and ARP messages so the A/B Switch is still able to monitor any IP address for the "auto-switch" features. The
administrator IP addresses can be different than the manager IP addresses. Any change will not become permanent
until a SAVE operation is performed.
GET ADMINIP N
Display the IP address of administrator N (1-8). If no value is entered for "N", then all administrator IP addresses
will be displayed.
ADMIN IP Addresses:
1: 192.168.1.113
2: 192.168.1.115
3: 192.168.1.149
SET MANAGER N X.X.X.X
Set SNMP manager N (1-16) IP address. Up to 16 SNMP MANAGER IP addresses can be entered for destinations
of trap messages. Trap messages will be sent to all enabled MANAGER IP addresses. To remove an entry from the
list, set the IP address to 0.0.0.0. Any change will not become permanent until a SAVE and RESET operation
sequence is performed.
SNMP Manager Table:
1: 192.168.1.113
2: 192.168.1.115
A/B SWITCH WITH REMOTE INTERFACE
Page 14 of 22