Specifications - Black Box 12 VDC load User Manual

This equipment generates, uses, and can radiate radio-frequency energy, and if not installed and used properly, that
is, in strict accordance with the manufacturer's instructions, may cause interference to radio communication. It has
been tested and found to comply with the limits for a Class A computing device in accordance with the
specifications in Subpart B of Part 15 of FCC rules, which are designed to provide reasonable protection against
such interference when the equipment is operated in a commercial environment. Operation of this equipment in a
residential area is likely to cause interference, in which case the user at his own expense will be required to take
whatever measures may be necessary to correct the interference.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This digital apparatus does not exceed the Class A limits for radio noise emission from digital apparatus set out in
the Radio Interference Regulation of Industry Canada.

1. Specifications

Connectors:
A/B Switch Ports:
Ethernet Control Port:
Serial Control Port:
Remote Control/Status Port:
Power:
Indicators:
Switch position LEDs:
Command status LED:
Switches:
Power:
Power Consumption (typical):
Model
Base Model without Serial Control
Serial Control Model
Ethernet and Serial Control Model
Switching Load (CAT6)
Switching Load (DB9)
Switching Load (Multimode Fiber)
Switching Load (Singlemode Fiber)
On latching units, the switching load is applied for approximately 0.15 seconds during switching. On non-latching units, the
switching load is constant in the B state, and therefore must be added to the steady state load.
Remote Control Inputs: External dry contact not to exceed 100 ohms resistance including cable.
Output Status Relay Contact Rating: 30 VDC, 1A maximum (resistive)
Data Rates: switch ports on all models are transparent to data rates, formats & protocols
RJ45 CAT6 models support 10/100/1000 and 10G Ethernet
DB9 models support data rates in excess of 10 Mbps
Fiber Optic models support data rates in excess of 10Gbps
A/B SWITCH WITH REMOTE INTERFACE
FEDERAL COMMUNICATIONS COMMISSION
AND INDUSTRY CANADA
RADIO FREQUENCY INTERFERENCE STATEMENTS
(3) RJ45 CAT6, or
(1) RJ45 10Base-T port for remote control interface (E/N controllable
Female DB9 (serial controllable models only)
(1) 6 Position Pluggable Phoenix Terminal Block
(1) 3.5-mm power input
(2) position A and position B
(1) command executing
(2) momentary push button switches for A/B switch port control
100-240VAC, 50/60-Hz wall mount supply, 12VDC output
12 VDC load
20 mA DC
40 mA DC
110 mA DC
Additional 65 mA DC
Additional 80 mA DC
Additional 95 mA DC
Additional 75 mA DC
(3) DB9F, or (3) ST, SC, FC or LC (depending on model)
120 VAC load
15 mA (AC RMS)
20 mA (AC RMS)
35 mA (AC RMS)
Additional 20 mA (AC RMS)
Additional 20 mA (AC RMS)
Additional 25 mA (AC RMS)
Additional 20 mA (AC RMS)
models only)
Page 2 of 22