Black Box 12 VDC load User Manual page 11

System Status: A
SET SYSTEM A[B]
Sets the system to position A or B.
SET IPADDRESS X.X.X.X
GET IPADDRESS
Set or display the current IP address of the network module. Any change will not become permanent until a SAVE
and RESET operation sequence is performed.
SET SUBNETMASK X.X.X.X
GET SUBNETMASK
Set or display the current subnet mask of the network module. Any change will not become permanent until a
SAVE and RESET operation sequence is performed.
SET GATEWAY X.X.X.X
GET GATEWAY
Set or display the current gateway IP address of the network module Any change will not become permanent until a
SAVE and RESET operation sequence is performed.
SET PINGREPLY ON[OFF]
GET PINGREPLY
Set or display whether or not the A/B Switch will respond to incoming PINGs (ICMP echo requests). Any change
will not become permanent until a SAVE operation is performed.
SET SNMPENABLE ON[OFF]
GET SNMPENABLE
Set or display whether or not the SNMP interface on the A/B Switch is enabled. Any change will not become
permanent until a SAVE operation is performed.
SET READCOMMUNITYNAME string
GET READCOMMUNITYNAME
SET WRITECOMMUNITYNAME string
GET WRITECOMMUNITYNAME
Set or display the current read or write community name as specified. Note that in general these are case sensitive
fields. Any change will not become permanent until a SAVE and RESET operation sequence is performed.
SET WEBENABLE ON[OFF]
GET WEBENABLE
A/B SWITCH WITH REMOTE INTERFACE
Page 11 of 22