Console Commands - Black Box 12 VDC load User Manual

7. Console Commands

The following commands are available from the RS232 console port or from the Ethernet network port on models of
the A/B Switch that support these remote control interfaces. All commands are case insensitive, although several
parameters are case sensitive (read/write community names and web and telnet passwords). GET, SET, and
SYSTEM can all be abbreviated by the first letter of the command. This allows shorthand entry of switching
commands. Each available command is shown along with an example of a typical response.
GET ALL
Displays all parameters and settings. An example output is shown here.
System Status: B
IP Address: 192.168.1.39
MAC Address: 00 06 57 00 01 02
Subnet Mask: 255.255.255.0
Gateway IP Address: 192.168.1.1
PING Reply: Enabled
SNMP Enable: Enabled
Read Community Name: public
Write Community Name: private
Web Enable: Enabled
Web Password: mctech
Web Timeout: 300
Web Port: 80
Telnet Enable: Enabled
Telnet Password: dataman
Telnet Timeout: 80
Telnet Port: 23
Monitor IP Address: 192.168.1.113
Monitor MAC Address: 00 00 00 00 00 00
Monitor Interval: 10
Monitor Fail Count: 5
Monitor Ok Count: 5
Authentication Trap: Disabled
Alert Type: TRAP
D1000: 2.9N JUL 2010, d1000 Rev B
ADMIN IP Addresses:
SNMP Managers:
1: 192.168.1.113
2: 192.168.1.115
3: 192.168.1.149
GET VERSION
Displays the software revision of the system.
D1000: 2.9h MAY 2008, d1000 Rev B
GET SYSTEM
Displays the system status. This is the same as the status returned by the SNMP variable d1000SwitchControl. It
will report "A" if the switch is in position A, and "B" if the switch is in position B.
A/B SWITCH WITH REMOTE INTERFACE
Page 10 of 22