Black Box 12 VDC load User Manual page 15

GET MANAGER N
Display SNMP manager N (1-16) IP address.
GET MANAGER
Display all SNMP manager IP addresses.
PING X.X.X.X
Causes the A/B Switch to issue a single ICMP echo request packet to the designated IP address. If a response is
received, the A/B Switch will display the message "Reply from X.X.X.X". If no response is received within 5
seconds, the A/B Switch will display the message "Request timed out".
SAVE
Save settings for next startup. All settings are stored in NV memory and restored upon power on. Any change will
not become permanent until a SAVE and RESET operation sequence is performed.
RESET
Causes a network system reboot and reloads all parameters from stored settings. Note that you will lose your
connection and have to log in again if giving this command from a telnet or web interface session.
SET DEFAULTS
Causes the A/B Switch configuration parameters to be restored to the factory settings. Any changes to the settings
will not become permanent until a SAVE and RESET operation sequence is performed.
HELP
Displays a list of commands.
>help
D1000 CONSOLE COMMANDS:
GET ALL (display all parameters)
GET VERSION (display software versions)
GET[SET] SYSTEM [A/B] (control all system ports)
GET[SET] IPADDRESS [X.X.X.X]
GET[SET] SUBNETMASK [X.X.X.X]
GET[SET] GATEWAY [X.X.X.X]
GET[SET] PINGREPLY [ON/OFF]
GET[SET] SNMPENABLE [ON/OFF]
GET[SET] READCOMMUNITYNAME [string]
GET[SET] WRITECOMMUNITYNAME [string]
GET[SET] WEBENABLE [ON/OFF]
GET[SET] WEBPASSWORD [string]
GET[SET] WEBTIMEOUT [N] (seconds)
GET[SET] WEBPORT [N]
GET[SET] TELNETENABLE [ON/OFF]
GET[SET] TELNETPASSWORD [string]
A/B SWITCH WITH REMOTE INTERFACE
Page 15 of 22