Table of Contents
Advertisement
9.3.2
Auto Patrol
9.3.3
Mask Zone
Building Technologies
Fire Safety & Security Products
1. Select Image Parameters > Auto Patrol.
2. Configure the options as described in the tables below.
3. Click Save.
Tilt Angle
The PTZ camera tilt angle can be configured for different application
requirements. Set up tilt angle from -90° to 30°.
(Scan) Speed
The auto scan speed can be configured between 1 and 90°/s. Higher
values will result in a higher tilt speed.
Patrol setup
There are 4 auto patrol settings for end user selection. The auto patrol
function will continuously scan up to 64 preset positions and is not
limited by the scan range.
Stop Time
Select the time for which the camera will stop at each position during
scanning between 5 and 60 s
Preset selection
Select the presets between 1 and 64 that will be called during the
patrol.
The masking function can be activated only with the correct streaming settings. See page
[
23] .
1. Click Image Parameters > Mask Zone.
2. Select ON, then click Set Mask Zone to start mask setting.
Configuration
CCMx1315-LP Configuration Manual EN
05.05.2009
33
Hide quick links:
Advertisement
Table of Contents
