Installing the camera
Using the Web-Cam IP manager
Fire Safety & Security Products
For details about the procedure, refer to the user's guide of the personal
3. Test the camera connection using ping.
Start a command prompt. Type "ping 192.168.0.10".
If the "Reply from..." message appears, the connection is correctly
4. Enter the camera's IP address in the address bar of the IE browser.
- OR –
Search the camera with the "Web-Cam IP Manager" application. See page
5. Log-in with the administrator ID. See page [
The Web-Cam IP Manager is an application for searching for network cameras that
can currently be viewed from the administrator's personal computer or a user's
personal computer, and connecting to those cameras.
Use the Web-Cam IP Manager Version 2.0 (Web IP Manager.exe) if all the units
are located in the same network segment.
Use the Web-Cam IP Manager Version 3.0 (IPFinder.exe) if the units are NOT
located in the same network segment. In that case, you must ensure that
associated gateway (router) passes the SSDP (Simple Service Discovery Protocol)
multicast messages sent by the Web-Cam IP Manager to the network segment
where the device is located.
To search a camera in the network:
1. Start the Web-Cam IP Manager (The file is included on the utilities CD).
The Web-Cam IP Manager program window will open:
CCMx1315-LP Configuration Manual EN