Precor P80 Operating And Maintaining page 106

Assembling the Treadmill
To install the accessory jack panel (treadmills with P80
consoles only):
1.
2. Feed the console cable assembly downward through the
3. Pass the lower end of the television cable through the
Remove the two #10 x ¹ ₂-inch Phillips-head machine
screws securing the blank plate at the right front corner of
the treadmill, as shown in the following figure. Discard the
blank plate.
Figure 8: Blank plate removal
cable channel in the upright support on your right. Drape
the remaining cable over the inside edge of the support
and tape it into place if necessary to secure it temporarily.
right-hand grommet and attach its F-type connector to
the connector on the inward side of the jack panel. Using
a ⁷ ₁₆-inch torque wrench, tighten the connectors to 30
in-lb.
27