Precor P80 Operating And Maintaining page 103

24
To begin assembly of the frame:
1.
2. Place the upright supports on the treadmill deck, next to
3. Feed the data cable from the treadmill drive unit through
4. Place the upright support on your left onto its base frame
5. Secure the upright support to the side bracket using three
Assembling and Maintaining TRM 800-Series Treadmills
Gently flex the bottom front edge of the treadmill hood
forward and around the bracket at the front of the
treadmill base. Lift the hood off of the treadmill base and
set it aside.
Figure 4: Hood removal
the base frame side brackets where you will be installing
them.
the cable channel in the upright support on your left, from
bottom to top.
side bracket, making sure that the rounded edge of the
upright support faces you.
³ ₈-inch × 1-inch buttonhead screws and three ³ ₈-inch
narrow flat washers. Partially tighten the fasteners using a
⁷ ₃₂-inch hex wrench.
Figure 5: Upright support attachment