Samsung SDS-P3042 Quick Start Manual page 61

HDD Alarm
You can set alarm settings for HDD defects such as Check Alarm Output Port, Replace Alarm Output Port,
and its duration.
Using the mouse may help make setup easier.
1. Use the up/down buttons (▲▼) in <Device> window to
move to <Storage Device>, and press [ENTER] button.
2. Select <HDD Alarm>.
A window for setting HDD check and replace output ports
and their durations appears.
3. Use direction buttons (▲▼◄ ►) to move to the desired
item.
Check Alarm Output Port : If HDD generates check alarm,
the alarm signal will output to the specified alarm output
port.
Replace Alarm Output Port : If HDD generates replace alarm, the alarm signal will output to the specified
alarm output port.
Duration : Sets the alarm duration for the alarm signal and beep sound.
- If <BEEP> was selected, a beep will sound.

M
<Check> status means that the HDD is operating but it has problems that require technical examination.
( ) appears on the Live screen.

<Replace> status means that the HDD has defect and requires immediate replacement.
( ) appears on the Live screen.

If the installed HDD is not recognized properly, a confirmation popup will appear.
4. When the HDD Alarm setup is done, press <OK>.
Storage Device
HDD Alarm
Device Format
Check Alarm Output Port BEEP
Duration OFF
Replace Alarm Output Port BEEP
Duration OFF
OK Cancel
English _49