main menu
Setting the PTZ
To use Camera's PTZ functions, ID and protocols of each camera and DVR should be matched.
For other settings, refer to the <Remote
Using the mouse may help make setup easier.
1. Use the up/down buttons (▲▼) in <Device> window to
move to <Camera>, and press [ENTER] button.
2. Select <PTZ>.
A window of PTZ settings appears.
3. Use direction buttons (▲▼◄ ►) to move to a desired
item, and select it.
Port : Select a port control method for the camera that is
connected to a channel.
You have two choices : <RS-485> and <Coaxial>.
For the <Coaxial> type, only SDR-5102 is supported.
ID : Set the ID of the connected camera of each channel.
You can easily setup by using the numeric buttons on the remote control.
Protocol : Set the protocol of the connected camera of each channel.
M
You can check the camera's ID and protocol if you turn the camera off and on after connecting it to the
For the <Coaxial> type, CCVC and PELCO-C protocols are supported.
For the <Coaxial> type, only SDR-5102 is supported.
4. When the PTZ setup is done, press <OK>.
46_ main menu
Device>
settings. (Page 50)
Camera
PTZ
Camera
CH
Port
ID
>
1
RS-485
0
>
2
RS-485
1
>
3
RS-485
2
>
4
RS-485
3
>
5
RS-485
4
>
6
RS-485
5
>
7
RS-485
6
>
8
RS-485
7
Previous/Next Page
OK
Cancel
Protocol
None
None
None
None
None
None
None
None
DVR.