Ip Tx Menu - Adtec EN-91 User Manual

IP Tx Menu

Note: this is a parallel menu. It has four index. Use the left or right arrows to navigate to
desired index.
Item
Mode
Tx IP Address
Tx Port
DVB per IP
RTP
FEC Mode
FEC L
FEC D
TOS
TTL
Tx Connector
Function
Enables IP Egress.
IP Address on which a transport
stream is transmitted.
port assignment used for
transmitting a multicast
Allows the operator to select how
many DVB packets to insert into
each Ethernet frame.
allows for sequence numbering
and timing; editable if Multicast
Mode is set to 'Send'
Forward Edge Correction; selects
on/off. When selected, sends two
FEC RTP streams in addition to a
source RTP stream enabling a
receiver to reconstruct missing
packets in the source stream.
affects the maximum
burstpacket loss that can be
recovered
defines latency involved in
burstrecovery
Allows the operator to sets the
TOS bits in the IPv4 header of
the TSoIP payload
Time-to-Live; specifies the
number of iterations or
transmissions the packet can
undergo before it is discarded
sets the physical connector (on
Options
Off
Send
user-defined using the numeric
keypad
user-defined using the numeric
keypad
1
4
7
On
Off
OFF
ON
MAXBURST
BURST
LOWLATENCY
4-20
4-20
0 = Normal service
2 = Minimize monetary cost
4 = Maximum reliability
8 = Maximize through put
16 = Minimize delay
user-defined using the numeric
keypad
Ethernet