Modulator Lineup; To Access The Menu; To Select The Desired Carrier Mode; To Set Transmit To Enabled Or Disabled - Adtec EN-91 User Manual

Modulator Lineup

This feature enables the operator to quickly view and/or configure select modulator RF
output parameters. The parameters available in this menu are;
1. Carrier Mode:
2. Transmit:
3. Output Power:
4. Output Frequency:
To access the menu, press the F1 and F2 keys simultaneously. The front panel will briefly
flash "MODULATOR LINEUP" then display the menu.
Note: To use this feature, the front panel display must be illuminated. If the display is
dim, press ANY front panel button to illuminate it.
Note: If the unit has been previously configured by the operator and powered OFF and ON,
then the display will read the last valid configuration, however, Tx will read
DISABLED.
To select the desired Carrier Mode, press the front panel "SELECT" button.
To set Transmit to ENABLED or DISABLED, press the front panel "ENTER" button.
To set the desired output Power Level, press and hold the front panel ↑ or ↓ button.
To set the desired output Modulator Frequency, press and hold the front panel ← or →
button.
Note: If the Modulator Frequency is reconfigured when Transmit = ENABLED, then
Transmit will be automatically set to DISABLED.
[ PURE_CARRIER or ON ]
[ ENABLED or DISABLED]
[ in 0.5dB increments ]
[ in 1.0MHz increments ]