Specifications - Icom IC-F210 Service Manual

SECTION 1
Measurement method
Frequency coverage*
Type of emission
Number of conventional channels
Antenna impedance
Power supply voltage (negative ground)
Current drain (approx.)
Usable temperature range
Dimensions (proj. not included)
Weight
RF output power
Modulation system
Maximum permissible deviation
Frequency error
Spurious emissions
Adjacent channel power
Audio frequency response
Audio hormonic distortion
FM hum and noise (typical)
(without CCITT filter)
Residual modulation (typical)
(with CCITT filter)
Limitting charact of modulator
Microphone connector
Receive system
Intermediate frequencies
Sensitivity (typical)
Squelch sensitivity (at threshold)
Hum and noise* 2
Adjcent channel selectivity
Spurious response
Intermoduration
Audio output power
External SP connector
1
* : depended on versions.
2
* : [EUR] is measured with CCITT filter, [USA] and [GEN] are measured without CCITT filter.
All stated specifications are subject to change without notice or obligation.

SPECIFICATIONS

EIA-152-C/204D or TIA-603
1
N/W: (12.5 kHz; Narrow/25 kHz; Wide): 8K50F3E/16K0F3E
N/M (12.5 kHz; Narrow/20 kHz; Middle): 8K50F3E/14K0F3E
–30˚C to +60˚C (–22˚F to +140˚F)
150(W)
150(W)
Range from 300 Hz to 2550 Hz [Narrow] / 3000 Hz [Middle], [Wide]
34 dB (min.), 40 dB (typ.)
40 dB (min.), 46 dB (typ.)
0.25 µV typical at 12 dB SINAD
34 dB (min.), 40 dB (typ.)
40 dB (min.), 45 dB (typ.)
[GEN], [USA]
400.000–430.000 MHz or 440.000–490 MHz
(12.5 kHz; Narrow/25 kHz; Wide): 8K50F3E/16K0F3E
maximum 128 channels
50 Ω nominal (SO-239)
13.6 V DC nominal
TX; 7.0 A (at 25 W), 13.0 A (at 45 W)
Rx; 1200 mA
300 mA
× ×
40(H) 117.5(D) mm; 5
× ×
40(H) 167.5(D) mm; 5
0.8 kg; 1 lb 12 oz [25 W], 1.1 kg; 2 lb 7 oz
High/Low2/Low1: 25 W/10 W/2.5 W
High/Low2/Low1: 45 W/25 W/ 5 W
Variable reactance frequency modulation
±2.5 kHz [Narrow], ±4.0 kHz [Middle], ±5.0 kHz [Wide]
±2.5 ppm
70 dB (typical)
60 dB minimum [Narrow]; 70 dB minimum [Middle], [Wide]
+2 dB to –5 dB of 6 dB/octave
3% typical at 1 kHz (40% deviation)
[Narrow]
–
70 – 100% of maximum deviation
8-pin modular (impedance: 600 Ω)
Double-conversion superheterodyne system
1st: 46.35 MHz, 2nd: 450 kHz
0.25 µV typical
[Narrow]
[Wide]
60 dB (min.), 65 dB (typ.)
70 dB (min.), 75 dB (typ.)
70 dB (min.), 75 dB (typ.)
4.0 W typical at 10% distortion with a 4 Ω load
2-conductor 3.5 (d) mm (
1 - 1
[EUR]
ETS 300 086
13.2 V DC nominal
(maximum audio)
(stand-by)
–25˚C to +55˚C
× ×
29 9 5
⁄ (W) 4 ⁄ (H) 4 ⁄ (D) inch
32 16 8
× ×
29 9 19
⁄ (W) 4 ⁄ (H) 6 ⁄
32 16 32
[45 W]
±1.5 kHz
0.25 µW ≤ 1GHz, 1.0 µW > 1 GHz
[Wide]
40 dB (min.), 50 dB (typ.)
43 dB (min.), 53 dB (typ.)
45 dB (min.), 55 dB (typ.)
–4 dBµV (emf) typical at 20 dB SINAD
–4 dBµV (emf) typical
40 dB (min.), 50 dB (typ.)
43 dB (min.), 53 dB (typ.)
45 dB (min.), 55 dB (typ.)
75 dB
65 dB (min.), 67 dB (typ.)
")/impedance: 4 Ω
1
⁄
8
[EUR]
[USA], [GEN]
[EUR]
[25 W]
(D) inch [45 W]
[25 W]
[45 W]
—
[Narrow]
[Middle]
[Wide]
[Narrow]
[Middle]
[Wide]
[Narrow]
[Middle]/[Wide]