EarthWay 2170 Assembly And Operating Instructions Manual

P
LEASE CALL US IF YOU HAVE ANY DIFFICULTY WITH THIS
SPREADER BEFORE RETURNING TO THE STORE
REACHED VIA PHONE AT
M —F 9:
ONDAY RIDAY OOAM
. .
WWW EARTHWAY COM
HELPFUL HINTS:
If your spreader does not spread evenly, be sure the FRONT on the gear box points to the front of the spreader. The impeller must
turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the impeller plate after each use.
Fertilizer stuck on the impeller blades will cause uneven spreading.
Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds will change
the spread patterns. Wet fertilizer will also change the spread pattern and flow rate. Clean your spreader thoroughly after each use.
Wash between the shut off plate and bottom of the hopper.
Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
When using Rock Salt remove the agitator to prevent damage to the gearbox and remove salt from the hopper daily. Rock Salt will
reconstitute back into a solid block over night with humidity.
1.
Remove and identify loose parts from carton.
2.
Position hopper on side. Install frame using (4) 1/4-20
x 1-½" Pan Head Philips machine screws and (4) 1/4-20
nylon insert locknuts. First, put bolts through holes in
frame, then through holes in bottom of hopper. Secure with
locknuts. Tighten these locknuts now.
. W
800-294-0671 574-848-7491
OR
~ 3:00
PM OR ONLINE AT
READ THE DIRECTIONS BEFORE ASSEMBLY
ASSEMBLY and OPERATING INSTRUCTIONS
E CAN BE
R S
OCK ALT IS NOT RECOMMENDED FOR USE IN
THIS SPREADER
EarthWay
E
for
MODEL 2170
Broadcast Spreader
. 9-06
REV
. R
EMOVE AGITATOR WHEN
I M .
USING CE ELT
®
-N-S
V PRED
PAGE 1
Pt. #52164