EarthWay 2170T Assembly And Operating Instructions Manual

2170T C
ommerCial
B
roadCasT
ASSEMBLY and OPERATING INSTRUCTIONS
PLEASE CALL IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS
REGARDING THE SAFE OPERATION OF THIS SPREADER. THIS MODEL INCLUDES LIFETIME TECHNICAL SUPPORT
SUPPORT HOT LINE: 574-848-7491 or 800-294-0671,
HELPFUL HINTS:
; If your spreader does not spread evenly, be sure the FRONT on the gear box points away from the tow bar of the spreader.
The impeller must turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the
impeller plate after each use. Fertilizer stuck on the impeller blades will cause uneven spreading.
; Your spreader is designed to be pulled at three miles per hour, which is a brisk walking speed. Slower or faster speeds will
change the spread patterns. Wet fertilizer will also change the spread pattern and flow rate. Clean and dry your spreader
thoroughly after each use. A coating of light spray oil will help prevent corrosion. Wash between the shut off plate and
bottom of the hopper.
; Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
33117
32100
Qty 1
Qty 2
36210
31100
Qty 2
Qty 7
36214
Qty 4
12152
Qty 2
1. Remove and identify all loose parts from carton
(Qty 4 #36214)
1/4-20 X 1-1/2"
Philips Panhead
T
ow
s
preader
READ THE DIRECTIONS BEFORE ASSEMBLY
36300
32103
Qty 6
Qty 8
36105
Qty 1
33108
Qty 1
31114
Qty 2
31106
Qty 3
12148
Qty 2
.
(Qty 4 #36300)
2. Position hopper on side. Install frame using (4) 1/4-20 x 1-1/2" Pan Head
1/4-20 SS Locknut
Phillips machine screws and (4) 1/4-20 nylon insert locknuts. First put bolts
through holes in frame then through holes in bottom of hopper. Secure with
locknuts. TIGHTEN THESE LOCKNUTS NOW
: @
email TeChsupporT earThway
36
33109
Qty 1
DO NOT TIGHTEN WITH POWER TOOLS.
EarthWay
EarthWay
EV-N-SPRED
EV-N-SPRED
GT GT
Rev.1-10
.
Com
12
22
37
18
15
14
28
Pt# 52165
® ®
9
21
6
9
10
PAGE 1