Amana AXP Series Service Training Manual page 57

During oven operation the display may indicate one of the following:
CALL SERVICE CALL SERVICE
CODE G0 CODE G0
DOOR DOOR
OPEN OPEN
CLOSE DOOR CLOSE DOOR
PLACE FOOD PLACE FOOD
IN OVEN
OPERATIONAL CODES
1. When you press the pad/ knob to preheat the oven the display indicates.
2. During cooking, the oven display indicates.
1. After food is placed in the oven the door is closed the display indicates.
1. After food is placed in the oven the door is closed the display indicates.
1. Unplug / plug oven in
2. If code continues to appear
replace Electronic Limiter.
3. If code continues to appear
after replacing Electronic
Limiter replace Thermocouple.
Note: When replacing thermocouple
position the thermocouple in the same
position in the cabinet as the original
thermocouple.
See component test procedures section
for testing procedures and results.
1. Inoperative Monitor Switch
2. Interlock Switch Assembly out of adjustment
3. Broken or loose wire connection
See component test procedures section
for testing procedures and results.
1. Interlock Switch Assembly out of adjustment
2. Inoperable Monitor Switch
3. Broken or loose wire connection