Replacing The Secondary Hard Disk Drive - Lenovo ThinkStation P300 Hardware Maintenance Manual

9. To install a new hard disk drive into the blue bracket, flex the bracket and align pin
and pin 4 on the bracket with the corresponding holes in the hard disk drive. Do not touch the circuit
board 5 on the bottom of the hard disk drive.
Figure 201. Installing the hard disk drive into the bracket
10. Slide the new hard disk drive into the drive cage until it snaps into position.
Figure 202. Installing the primary hard disk drive
11. Connect the signal cable and the power cable to the new hard disk drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 223.

Replacing the secondary hard disk drive

Important: Before you replace any FRU, be sure to read and understand Chapter 1 "Safety information"
on page 1.
1 , pin 2 , pin
.
Chapter 8 Replacing FRUs
3 ,
203