Lenovo ThinkStation P300 Hardware Maintenance Manual page 187

8. Install a new solid-state drive into the storage converter. Then install the four screws to secure the
new solid-state drive to the storage converter.
Figure 170. Installing the new solid-state drive into the storage converter
9. To install the storage converter into the 3.5-inch hard disk drive bracket, flex the bracket and align pin
pin 2 , pin 3 , and pin
Figure 171. Installing the storage converter with the new solid-state drive into the hard disk drive bracket
10. Install the storage converter with the bracket into the hard-disk-drive bay. See "Replacing the primary
hard disk drive" on page 201 or "Replacing the secondary hard disk drive" on page 203.
11. Connect the signal cable and the power cable to the solid-state drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
4 on the bracket with the corresponding holes in the storage converter.
.
Chapter 8 Replacing FRUs
1 ,
181