10. Align the drive cage pivot pin with the slot 1 in the upper drive cage and
11. Connect the signal and power cables to the rear of the new hard disk drive.
Figure 23. Installing the primary hard disk drive and bracket
12. Press down on the metal latch 2 , pivot the drive cage into place, and then
13. Go to Chapter 4, "Completing the parts replacement," on page 45.
Replacing the secondary hard disk drive
28
Hardware Installation and Replacement Guide
slide the hard disk drive cage into the chassis.
slide it forward until it snaps into position.
Note: There are two arrows, one on the upper drive cage and one on the hard
disk drive cage. The arrows are aligned when the hard disk drive is in
the proper position.
Attention
Do not open your computer or attempt any repair before reading the "Important safety
information" in the Safety and Warranty Guide that was included with your computer. To
obtain a copy of the Safety and Warranty Guide, go to the Support Web site at
http://www.lenovo.com/support.