Replacing The Front Audio And Usb Assembly - Lenovo ThinkStation P300 Hardware Maintenance Manual

4. Note the orientation of the eSATA connector or IEEE 1394 connector and route the eSATA connector or
IEEE 1394 connector cable into the cable clip.
5. Place the eSATA connector or IEEE 1394 connector into the metal retainer. Then insert the eSATA
connector or IEEE 1394 connector into the corresponding slot in the flex module as shown.
Figure 39. Installing the eSATA connector or IEEE 1394 connector in the flex module
6. Position the flex module cover on the flex module so that the rail guides on the bottom of the flex module
cover engage the rails on the flex module. Then, push the cover to the front of the flex module until
it snaps into position.
Figure 40. Reinstalling the flex module cover
7. Connect the eSATA connector or IEEE 1394 connector cable to the corresponding connector on the
system board. See "Locating parts on the system board" on page 72.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 142.

Replacing the front audio and USB assembly

Important: Before you replace any FRU, be sure to read and understand Chapter 1 "Safety information"
on page 1.
.
Chapter 8 Replacing FRUs
99