Lenovo ThinkStation P300 Hardware Maintenance Manual page 103

5. Note the orientation of the new card reader and route the card reader cable into the cable clip. Hold
the clip on the card reader retaining bracket to insert the new card reader into the card reader slot in
flex module until it snaps into position.
Figure 35. Installing the card reader in the flex module
6. Position the flex module cover on the flex module so that the rail guides on the bottom of the flex module
cover engage the rails on the flex module. Then, push the cover to the front of the flex module until
it snaps into position.
Figure 36. Reinstalling the flex module cover
7. Connect the card reader cable to the USB 2.0 connector or card reader connector on the system board.
See "Locating parts on the system board" on page 72.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 142.
Installing or replacing an eSATA connector or IEEE 1394 connector in the flex module
To install or replace an eSATA connector or IEEE 1394 connector in the flex module, do the following:
1. Slide the flex module out of the front of the computer. See "Installing or replacing a device in the
optical drive bay" on page 90.
.
Chapter 8 Replacing FRUs
97