Lenovo ThinkStation P300 Hardware Maintenance Manual page 192

2. Remove the computer cover. See "Removing the computer cover" on page 144.
3. Lay the computer on its side for easier access to the system board.
4. Locate the heat sink and fan assembly. See "Locating parts on the system board" on page 79.
5. Disconnect the heat sink and fan assembly cable from the microprocessor fan connector on the system
board. See "Locating parts on the system board" on page 79.
6. Follow this sequence to remove the four screws that secure the heat sink and fan assembly to the
system board:
a. Partially remove screw
b. Partially remove screw
Note: Carefully remove the four screws from the system board to avoid any possible damage to the
system board. The four screws cannot be removed from the heat sink and fan assembly.
Figure 177. Screws that secure the heat sink and fan assembly
7. Lift the failing heat sink and fan assembly off the system board.
Notes:
• You might have to gently twist the heat sink and fan assembly to free it from the microprocessor.
• Do not touch the thermal grease while handling the heat sink and fan assembly.
8. Pivot the two plastic retaining clips that secure the heat sink fan duct outward. Then remove the heat
sink fan duct from the failing heat sink and fan assembly.
186
ThinkStation P300 Hardware Maintenance Manual
1 , then fully remove screw
3
, then fully remove screw
2 , and then fully remove screw
4
, and then fully remove screw
1 .
3
.