Replacing The Secondary Hard Disk Drive - Lenovo ThinkCentre M83 Hardware Maintenance Manual

Replacing the secondary hard disk drive

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Safety information" on page 1.
Note: Your computer comes with a secondary hard disk drive bay for installing or replacing a secondary
3.5-inch hard disk drive or a 2.5-inch solid-state drive. To install the solid-state drive, see "Installing the
mSATA solid-state drive" on page 120
This section provides instructions on how to replace the secondary hard disk drive.
To replace the secondary hard disk drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 93.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 94.
4. Disconnect the signal cable and the power cable from the hard disk drive.
5. Pull the blue handle to release and remove the hard disk drive from the hard disk bracket.
Figure 67. Removing the secondary hard disk drive
6. Flex the sides of the blue bracket to remove the hard disk drive from the bracket.
128
ThinkCentre M83 and M93/p Hardware Maintenance Manual