Installing Or Removing The Rear Wi-Fi Antenna - Lenovo ThinkStation P300 Hardware Maintenance Manual

2. Connect the front antenna cable and rear antenna cable to the Wi-Fi card module.
Figure 98. Installing the Wi-Fi antenna cables
3. Install the Wi-Fi adapter card into the PCI Express x1 slot on the system board. See "Locating parts on
the system board" on page 72.
4. If the installed Wi-Fi card module supports the Bluetooth function, use a Bluetooth cable to connect the
Bluetooth connector on the Wi-Fi adapter card to the front USB connector on the system board.
5. Pivot the card latch to the closed position to secure the Wi-Fi adapter card.
Figure 99. Installing the Wi-Fi adapter card
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 142.

Installing or removing the rear Wi-Fi antenna

Important: Before you replace any FRU, be sure to read and understand Chapter 1 "Safety information"
on page 1.
Installing the rear Wi-Fi antenna
To install the rear Wi-Fi antenna, do the following:
138
ThinkStation P300 Hardware Maintenance Manual