USB/card reader board
Description
USB/card reader board for use in models without WWAN (includes cable)
USB/card reader board for use in models with WWAN (includes cable)
Before removing the USB/card reader board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the keyboard/top cover (see
5.
Remove the battery (see
6.
Remove the WWAN/GPS module (see
Remove the USB/card reader board:
1.
Disconnect the cable from the system board (1).
2.
Remove the three Phillips PM2.0×3.0 screws (2) that secure the USB/card reader board to the computer.
3.
Rotate left side of board up and pull it toward the left to remove it from connectors, and then remove
the board from the computer (3).
Reverse this procedure to install the USB/card reader board.
34
Chapter 5 Removal and replacement procedures forAuthorized Service Provider parts
Keyboard/top cover on page
Battery on page
33).
WWAN/GPS module on page
Spare part number
792778-001
792769-001
23).
31).