Touchpad - HP Stream Notebook PC 13 Maintenance And Service Manual

TouchPad

Description
TouchPad for use in models without WWAN (includes cable)
TouchPad for use in models with WWAN (includes cable)
Before removing the TouchPad, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the keyboard/top cover (see
Remove the TouchPad:
1. Position the keyboard/top cover upside down with the front toward you.
2. Remove the two Philllips PM2.0×2.0 broad head screws (1) that secure the TouchPad to the keyboard/
top cover.
NOTE:
keyboard/top cover.
3. Remove the TouchPad and cable (2) by releasing them downward (3) from the top surface of the
keyboard/top cover.
Reverse this procedure to install the TouchPad.
When removing the TouchPad, make sure the cable is released through the opening in the
Keyboard/top cover on page
Spare part number
795911-001
792776-001
23).
Component replacement procedures 27