Usb/Card Reader/Power Button Board - HP 14-ck0 Series Maintenance And Service Manual

USB/card reader/power button board

Description
USB/card reader/power button board
USB/card reader/power button board cable
Before removing the USB/card reader/power button board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the display (see
Remove the USB/card reader/power button board:
1. Disconnect the cable from the ZIF connector on the USB/card reader/power button board (1).
2. Remove the two Phillips M2.0×3.0 screws (2), and then remove the board from the computer (3).
Reverse this procedure to replace the USB/card reader/power button board.
52 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Bottom cover on page
Battery on page 31).
Display assembly on page
29).
53).
Spare part number
L23196-001
L23186-001