Lp Gas Furnace; Heat Pump - Winnebago Sunflyer Manual

SECTION 8
APPLIANCES & INTERIOR FEATURES
LP GAS FURNACE (SUBURBAN)
To Start Up:
1. Close the LP gas tank valve.
System Switch
Fan Speed Switch
HEAT
COOL
OFF
FAN
SYSTEM
BUILT IN TIME DELAY AND FUSE PROTECTION
2. Slide thermostat switch from OFF to HEAT.
NOTE: If your coach is equipped with the
optional electic Heat Pump, be sure the
Heat Source switch is in GAS position.
See Heat Pump for details.
Heat Source Switch
ELECTRIC = Heat Pump
GAS = Furnace
3. Set thermostat above room temperature to
begin blower operation. A slight delay will
occur before the blower comes on. Allow
blower to run for 5 minutes for combustion
chamber purge cycle.
4. After 5 minutes, move thermostat lever
below room temperature. Blower will remain
on. Wait approximately 2 minutes for blower
to go off.
8-12
Temperature Selector
90
85
80
HIGH
75
AUTO
LOW
70
LOW
65
ON
HIGH
60
FAN
55
5. Open LP gas tank valve.
6. Set thermostat to desired temperature. If set
above room temperature, blower will come
on.
7. Allow 30 seconds for main burner to light
after blower comes on. This furnace is
equipped with an ignition device which auto-
matically lights the burner. Do not try to light
the burner by hand.
8. If burner does not light, repeat Steps 1
through 5. (If heat does not come out of the
heat duct after a minute or so, the burner is
not lit.)
9. If after three (3) attempts with no ignition, go
to shut-down and contact your dealer or a
local recreational vehicle service center. Do
not continue to cycle furnace through ther-
mostat in an attempt to get ignition.
To Shut Down:
1. Slide thermostat switch to OFF position.
2. Close LP tank valve.
NOTE: For normal operation after initial start-
up, be sure the thermostat switch is in
HEAT position, then place the tempera-
ture selector to the desired temperature.
The furnace will start and cycle on and
off automatically.
Changing Temperature Setpoint
Move the temperature Selector to the desired
temperature on the display. The display will
change with the position of the Selector. (The
display normally shows the current room tem-
perature until the Temperature Selector lever is
moved.) When you have chosen a temperature
setting, the display will continue to show the
selected temperature value for 3 seconds, then it
will revert to showing current room temperature.
For Further Information
Please see the Suburban furnace operating
instructions provided in your InfoCase for fur-
ther information, including operating precau-
tions, and periodic maintenance.
HEAT PUMP - Optional
Your coach may be optionally equipped with