Winnebago Sunflyer Manual page 88

SECTION 8
APPLIANCES & INTERIOR FEATURES
The TEMP SET (thermostat) button (D) con-
trols the refrigerator and freezer temperature
during both gas and electric operation. Press and
hold the TEMP SET button to select the desired
temperature setting. The temperature settings are
shown in the form of LED's (A). The illumi-
nated LED indicates the temperature setting,
with COLD on the left and COLDEST on the
right. The temperature LED turns off after 10
seconds. Quickly press and release tempset but-
ton to display the temperature setting.
Start-Up Instructions - Auto Mode
When the AUTO mode is selected, the oper-
ating control automatically selects the power
source using the following priority scheme:
• When 120 volts AC is available to the refrig-
erator, the AUTO LED and the AC LED will
illuminate, indicating the refrigerator is oper-
ating on AC electric.After 10 seconds, the
AC LED will turn off and only the AUTO
LED will remain illuminated. Press and
quickly release mode button to display the
operating mode.
• If 120 volts AC is not available, the refriger-
ator will switch to the gas operation. The
AUTO LED and the LP GAS LED will illu-
minate. After 10 seconds, the LP GAS LED
will turn off and only the AUTO LED will
remain illuminated. Press and quickly
release mode button to display the operating
mode.
During operation in the AUTO mode, when
a higher priority power source becomes avail-
able, the operating controls will cease using the
current power source and will switch to the
higher priority power source. For example, if
AC electric becomes available while the refrig-
erator is operating in the AUTO LP GAS mode,
the refrigerator will switch to AUTO AC opera-
tion.
If an operating mode is not functional, its
corresponding LED will flash and the refrigera-
tor will attempt to operate in a lower power pri-
ority source. If a lower power priority source is
not available, the LED will continue to flash,
and the refrigerator will cease operation until the
8-2
energy source is corrected. Refer to the "Diag-
nostic" section on page 7 of the "Norcold 9100
Series Refrigerators Operator's Guide" in your
InfoCase.
Start-Up Instructions - Manual Mode
To operate the MANUAL mode, press and
hold the MODE button (C) until the AUTO LED
disappears and the desired operating mode is
displayed. If the power source is interrupted
while operating in the MANUAL mode, the
AUTO LED disappears and the desired operat-
ing mode is illuminated. Unlike AUTO mode,
the operating mode LED remains illuminated
until an alternate mode is selected. If the energy
source is interrupted while in the MANUAL
mode, the corresponding LED flashes, and the
refrigerator ceases operation until an alternative
energy source is selected or the problem is cor-
rected. Refer to the "Diagnostics" section on
page 7 of the Norcold Operator's Guide in your
InfoCase for corrective actions.
AUTO and MANUAL Modes - Gas Operation
Only
If the gas does not ignite within 30 seconds,
which may occur on initial start-up, the refriger-
ator's gas valve will automatically close and the
operating controls will select an alternate power
source (AUTO Mode) or revert to a stand-by
mode in which the LP GAS LED flashes. The
LED continues to flash until the refrigerator is
turned OFF and then ON. If the gas does not
ignite after several attempts, check the input gas
supply, or consult with your dealer or a Norcold
authorized service center. A different mode of
operation may be selected by pressing and hold-
ing the MODE button. The refrigerator will not
switch to the new operating mode until the
MODE button is released.