Trailer Wiring Connector - Winnebago Sunflyer Manual

WARNING
To prevent wiring damage, it is
essential when replacing the cables
on the battery, or when using a
"booster" battery, that the positive
post and the positive cable be
attached and the negative post and
negative cable be attached. The posts
are marked (+) plus and (-) minus. If
a "fast charger" is used while battery
is in the motor home, disconnect both
battery cables before connecting the
charger. Never attempt to charge or
boost a frozen battery.
BATTERY CONDITION METER
See related item under "Monitor Panel" in sec-
tion 8, Appliances.
AUX. START SWITCH
See section 2, Driving Your Motor Home for
information on Aux. Start Switch.

TRAILER WIRING CONNECTOR

Your coach is pre-wired for trailer or car tow-
ing lights with a 6-pin socket on the rear bumper.
The connector plug is supplied in the coach parts
package provided to you by your dealer when
you took delivery of the vehicle.
The diagram shows proper connection of trail-
er or tow vehicle wiring to the coach light system.
Remove the small screw near the end of the plug
and slide the contact assembly out of the barrel.
TM = Tail lights
GD = Ground
TM = Tail lights
LT = Left Turn*
GD = Ground
LT = Left Turn
RT = Right Turn*
RT = Right Turn
S = Brake lights
S = Brake lights
A = Backup lights
A = Backup lights
ELECTRICAL SYSTEMS
*NOTE: On Ford chassis, these turn signal con-
nection also include a brake light func-
tion.
SECTION 6
6-11