Water Heater By-Pass Valve; Lp Gas Furnace; Start Up; To Shut Down - Winnebago 2016 Adventurer Owner's Manual

Table of Contents

Advertisement

3. Pull the handle of the P-T valve straight out and allow water to flow until it stops.
4. Let the handle of the P-T valve snap shut.
5. Close the faucet and turn on the water supply before switching the water heater on.
Manually operate the pressure temperature relief valve at least once a year. OPERATE THIS VALVE ONLY
WHEN THE WATER HEATER AND COOLING SYSTEM ARE COLD!

WATER HEATER BY-PASS VALVE

Your coach may be equipped with a water heater by-pass valve for easier winterization of water lines using
RV antifreeze. The valve is located inside the coach near the water heater.
Line up the arrow on the handle with the appropriate arrow on the valve plate to either bypass or flow
through the water heater.
Leave by-pass valve handle in NORMAL FLOW position if draining water and blowing out water lines.
Place in BYPASS position ONLY when using antifreeze solution in water lines.

LP GAS FURNACE

Start Up:

1. Open the LP gas tank valve by turning fully counterclockwise.
2. Move the thermostat temperature selector from OFF position and place to desired temperature.
3. Furnace fan will start to blow immediately after setting thermostat.
4. After about 30 seconds, the furnace burner will light.
5. The furnace will now cycle off and on automatically as the thermostat demands just like a household
furnace.

To Shut Down:

1. Slide SYSTEM switch to "OFF" position.
2. Close LP tank valve.
NOTE: If heat does not come out of the heat ducts after a minute or so the burner is not lit. Turn thermostat off for 3-5
minutes, check to be sure tank valve is open and tank is not out of fuel, then try steps 2-4 again. If it still will
not light after three attempts, go to Shut Down steps and contact your dealer or a local RV service center.

TV ANTENNA - OPTIONAL

The RV antenna on your motor is an internal mounted concealed digital antenna which requires no
adjustment or setup. A built-in signal amplifier designed to strengthen signals is controlled by a power switch
built into the TV antenna.
CAUTION
49

Advertisement

Table of Contents
loading

Table of Contents