1-6-11 Removing the main charger unit
1. Remove the process unit from the printer (See page 1-6-2).
2. Unlatch the three snaps, and remove the main charger cap.
3. Draw the main charger unit in the direction of arrow A, then pull it out in the direction of arrow B.
Main charger unit
CAUTION
• When refitting the main charger unit, hold terminal down C, then push frontwards. Use care not to deform the terminal.
B
C
Terminal
Main charger
unit
Figure 1-6-32 Removing the main charger unit
A
Snaps
Main charger cap
2FM
Snap
1-6-31