Cable Connection - Fujitsu ETERNUS DX200F Setup Manual

Cable Connection

STEP
Various cables need to be connected to the rear of the ETERNUS DX.
Configuration Guide (Basic)
●
Point
●
The cables should never be bent, twisted or pulled.
IMPORTANT
LAN Cable
1
●
MNT port
A port that is used to connect to an operation management LAN. Before connecting to the operation
management LAN, change the IP address of the MNT port in the Setup Network Environment settings.
●
RMT port
A port that is used for initial setup or to connect to the remote support center.
Cable
Host Interface Cable
2
Connect a Host Interface cable to each of these ports.
Cable
●
FC, iSCSI 10Gbit/s
(for FC cable connection)
●
iSCSI 10Gbit/s
(for Copper Twinax cable
connection)
Power Cords
3
Connect the power cords to the inlets of the power supply unit.
Use release ties to hold the power cords in place.
Cable
To help with cable management and prevent incorrect connection, attach labels to the cables and make a
note of connection origins and destinations.
This step describes dual controller type as an example. Note that there is only controller 0 (CM#0) for single
controller type.
Rear view
Controller (CM#0)
Rear view
Rear view
FUJITSU Storage ETERNUS DX200F All Flash Array Setup Guide
Copyright 2014 FUJITSU LIMITED
Controller (CM#1)
RMT port MNT port
CA#0 CA#1
FC iSCSI 10Gbit/s
,
for FC cable connection
( )
Port#0 Port#1
3
RMT port MNT port
CA#0 CA#1
iSCSI 10Gbit/s
(for Copper Twinax cable connection)
Port#0 Port#1
P3AM-8482-01ENZ0