Default Settings - Alcatel-Lucent 7210 SAS-D Installation Manual

Initializing the System and Downloading Software
Page 60
TiMOS BOOT LOADER
Time from clock is THU APR 21 11:03:21 2011 UTC
Switching serial output to sync mode...
Since the switch does not ship with a BOF, it will show the default settings.
Looking for cf1:/bof.cfg ... not found
Could not find bof.cfg on any of the local drives.

Default Settings:

--------------------------------------------------------------------------
-----------------------
Contents of Boot Options File on cf1:
#uplinkA Port Settings:
uplinkA-port
uplinkA-address
uplinkA-vlan
#uplinkB Port Settings:
uplinkB-port
uplinkB-address
uplinkB-vlan
#System Settings:
wait
persist
console-speed
Hit a key within 2 seconds to change boot parameters...
Press any key.
Enter password to edit the Boot Options File
Or CTRL-D to exit the prompt
Password:
The default password is
You must supply some required Boot Options. At any prompt, you can type:
"restart" - restart the query mode.
"reboot" - reboot.
"exit" - boot with with existing values.
"diag" - enter the diag shell.
"reset" - reset the bof and reboot.
1/1/1
0
0
1/1/2
0
0
3
off
115200
.
password
7210 SAS-D Installation Guide
done