In-Band Access - Alcatel-Lucent 7210 SAS-D Installation Manual

Service access switch
Hide thumbs Also See for 7210 SAS-D:
Table of Contents

Advertisement

In-Band Access

NOTE:
The management agent can accept up to four simultaneous Telnet sessions. If the maximum
number of sessions already exists, an additional Telnet connection will not be able to log into the
system.
7210 SAS-D Installation Guide
You can access the management agent in the switch from anywhere within the
attached network using Telnet or network management software tools. However, you
must first configure the switch with a valid IP address, subnet mask, and default
gateway.
If you have trouble establishing a link to the management agent, check to see if you
have a valid network connection. Then verify that you entered the correct IP address.
Also, be sure the port through which you are connecting to the switch has not been
disabled. If it has not been disabled, then check the network cabling that runs between
your remote location and the switch.
Troubleshooting
Page 77

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents