Displaying Transceiver Module Information And Alarming Information - H3C SR6604 Installation Manual

To do...
Enter system view
Enter view of the SFP port or RJ-45
port of the combo interface
Activate the RJ-45 Ethernet port or
SFP port
Displaying transceiver module information and alarming
information
Introduction to transceiver modules
Table 18 Commonly used transceiver modules
Transceiver module type
SFP (Small Form-factor Pluggable)
XFP(10-Gigabit small Form-factor
Pluggable)
Displaying transceiver module information
To identify transceiver modules, you can use the following command to view the key parameters of the
transceiver modules, including transceiver module type, connector type, central wavelength of the laser
sent, transmission distance, and vendor name or name of the vendor who customizes the transceiver
modules.
Follow these steps to display transceiver module information:
To do...
Display key parameters of the
transceiver module in a specified
interface
Displaying the alarming information or fault detection parameters for a transceiver module
The system outputs alarm information for you to locate and troubleshoot faults of transceiver modules. For
the H3C-customized transceiver modules, the system can also monitor the key parameters, such as
temperature, voltage, laser bias current, TX power, and RX power. When these parameters are abnormal,
you can take corresponding measures to prevent transceiver module faults.
Perform the following operation to display the alarming information or fault detection parameters of a
transceiver module:
Use the command...
system-view
interface interface-type
interface-number
combo enable { copper | fiber }
Application scenarios
Generally used for
100M/1000M Ethernet
interfaces or POS
155M/622M/2.5G interfaces
Generally used for 10G
interfaces
Use the command...
display transceiver interface
[ interface-type interface-number ]
61
Remarks
—
—
Required
By default, the Ethernet port is active.
Whether can
Whether can
be an
be an optical
electrical
transceiver
transceiver
Yes Yes
Yes No
Remarks
Available for all
transceiver modules