Hipot (Dielectric Strength) Testing - RuggedCom RuggedSwitch RS900G Installation Manual

10-port managed ethernet switch with gigabit uplink ports

Hide thumbs Also See for RuggedSwitch RS900G:

Table of Contents

2.3 HIPOT (Dielectric Strength) Testing

Units which are to be "HIPOT" tested in the field must have the braided ground cable disconnected

(see Figure 2.3.1) during the HIPOT test. This is required in order to prevent the transient/surge

suppression circuitry, which is connected to Surge Ground (see Figure 2.3.1), from being activated

during the HIPOT test.

Figure 2.3.1 HIPOT (Dielectric Strength) Testing



Rev105

Table of Contents

Do you have a question about the RuggedSwitch RS900G and is the answer not in the manual?