Configuring Maxpro Nvr; Configuring The System Settings - Honeywell MAXPRO NVR XE Operator's Manual

C
ONFIGURING
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Configuring MAXPRO NVR involves the following tasks:
•
•
•
•
•
•
•
C
The System settings enable in configuring the following:
•
•
•
•
To configure the system settings
GENERAL SYSTEM SETTINGS
The general settings enable configuring of the device address, device name, and device
description for MAXPRO NVR.
To configure the general system settings
1.
MAXPRO NVR Operator's Guide
MAXPRO NVR

Configuring the System settings

Configuring the Disk Settings
Configuring the Cameras
Configuring the Schedules
Configuring the Input and Output for a camera
Configuring the Sequences
Performing User administration
O NF IG U R IN G T H E S Y S T E M S ET T IN G S
General System Settings
Event Recording Settings
Email Settings
Holiday/Exception Settings for Schedules
• Click the Configurator tab.The System page appears by default.
Under General Settings
• The Device Address displays by default.
• The Device Name displays by default.
Note: MAXPRO
NVR comes with a default IP address and a computer name. If you are
going to have more than one MAXPRO NVR on the network then you should
change the computer name and IP address. Each MAXPRO NVR unit has its own
unique computer name and IP address. Refer to the MAXPRO NVR Quick
Installation Guide for information on changing the IP address and computer
name.
• The Description of the device displays by default. You can type a new description as
applicable.
3
35